Car Fixed
GarageProLogin
2013
nissan altima24 views

Check Engine Light On

Expert diagnosis and repair solutions for 2013 nissan altima Check Engine Light On. Get step-by-step fixes, cost estimates, and professional advice.

Expert Repair Solutions

1
medium$150-$300
Replace the faulty oxygen sensor to resolve the Check Engine Light issue.
Source: https://www.autonationnissanchandler.com/service/check-engine-light.htm

Repair Steps:

  1. Locate the oxygen sensor in the exhaust system.
  2. Disconnect the electrical connector from the sensor.
  3. Use an oxygen sensor socket to remove the faulty sensor.
  4. Install the new sensor and reconnect the electrical connector.
  5. Clear the CEL using an OBD-II scanner.
2
easy$10-$30
Ensure the gas cap is properly tightened or replace it if damaged.
Source: https://www.dwnissan.com/nissan-check-engine-light.htm

Repair Steps:

  1. Inspect the gas cap for any visible damage or wear.
  2. Tighten the gas cap until it clicks to ensure a proper seal.
  3. Replace the gas cap if it is damaged or does not seal properly.
  4. Drive the vehicle for a few trips to see if the CEL turns off.
3
hard$100-$200 (dealer service)
Reprogram the Engine Control Module (ECM) to address calibration issues affecting the mass air flow sensor.
Source: https://static.nhtsa.gov/odi/tsbs/2016/MC-10119177-9999.pdf

Repair Steps:

  1. Check the vehicle's ECM part number to confirm if reprogramming is needed.
  2. Use a Nissan CONSULT-III plus diagnostic tool to connect to the vehicle's ECM.
  3. Follow the service procedure to update the ECM software.
  4. Verify the update by checking the ECM part number post-reprogramming.
  5. Clear any stored DTCs and test drive the vehicle to ensure the CEL is resolved.
4
medium$100-$250
Inspect and replace the mass air flow sensor if it is dirty or malfunctioning.
Source: https://www.crowngreenvillenissan.com/2013-nissan-altima-check-engine-light.htm

Repair Steps:

  1. Locate the mass air flow sensor near the air filter housing.
  2. Disconnect the electrical connector from the sensor.
  3. Remove the sensor from its housing.
  4. Clean the sensor using a mass air flow sensor cleaner if it is dirty.
  5. Replace the sensor if cleaning does not resolve the issue.
  6. Reinstall the sensor and reconnect the electrical connector.
  7. Clear the CEL using an OBD-II scanner.
5
hard$200-$500
Check and replace any faulty emissions control components that may be triggering the CEL.
Source: https://repairpal.com/nissan/altima/2013/check-engine-light

Repair Steps:

  1. Use an OBD-II scanner to identify specific DTCs related to the emissions system.
  2. Inspect components such as the catalytic converter, EGR valve, and EVAP system for faults.
  3. Replace any defective components as indicated by the diagnostic codes.
  4. Perform a system test to ensure all emissions components are functioning correctly.
  5. Clear the CEL and conduct a test drive to confirm the issue is resolved.

Get a Personalized Diagnosis

Get AI-powered repair suggestions specific to your vehicle's symptoms and history.

Start Free Diagnosis →
Browse more common problems